Criterion Rd1000 Trial Compressors And

The fourth screen displays the states of the compressor motor, fan motor, the phase sequence SULLAIR and remote disable.

Criterion Rd1000 Trial Compressors And

Individual seminars on Industrial compressors and compressor electrical systems are offered at regular intervals throughout the year at Sullairs corporate headquarters training facility located at Michigan City, Indiana.

Also all end user safety assembly and customer service fall under the Sullair rules for the same type of service must be adhered quality control system.

The hot saturated air is then contact your Sullair distributor and they will be able to passed directly into the RH series of dryers.

Keep the dryer clean.

Maintenance and repairs should only be 2.

The hot, saturated, compressed air from the compressor is forced into the air-cooled 1.

In case this safety switch has tripped, it has to be manually.

Make sure all air connections are intact and have no leaks b.

Also, the compressed air must be vented from the sys- tem and the inlet and outlet valves must be closed.

Inlet and outlet directions are identi- fied on the dryer and cannot be inter- changed.

Sullair dryers are factory tested prior to shipment.

Prior to installation, the dryer and the com- However, during shipment, there are chances that pressed air system are to be depressurized.

The dryer must be installed horizontally.

A 3.10.1 R minimum of at least 1 feet clearance EFRIGERANT COMPRESSOR around the dryer is necessary to allow free The refrigerant compressor is fully hermetically air circulation and easy access for servicing.

An airair heat exchanger which pre-cools pre-heating refrigerant compressor.

Low pressure section with an evaporator steady, and maintain the refrigerant tempera- (heat exchanger) ture in the heat exchanger, a hot gas by-pass.

Verify that the operating parameters match 3.14 ELECTRICAL CONNECTION with the nominal values stated on the data REQUIREMENTS nameplate of the dryer (voltage, frequency.

It is recommended to use the same pipe size as that of the dryer Inlet and Outlet.

Remove any packaging and other material BEFORE OPERATING which could obstruct the area around the dryer.

Read this manual completely.

Activate the mains switch.

Review all safety precautions.

Shut down the air compressor.

After few minutes, shut down the dryer pressing the button 0 - OFF of the ONOFF WARNING switch For short periods of inactivity, (max 2-3 NOTE.

In case of more than 4 pounds of refriger- ECHNICIAN ant, the dryer should be regularly checked 1.

Sullair zero loss drain has to be cleaned with soft water when needed.

The unit will not run or Line disconnect switch is Close the start or disconnect If the dryer is not operating, cycles off and on.

Modbus protocol used The RD product is effectively the RN product with a communication.

E-680 Controller.

Refer to Section 3.

The front panel of the controller contains a four line E-680 is designed as a controller for refrigerant type 20 character LCD display and 10 buttons that are.

If the dryer is stopped manually, it can not be started before restart delay.

Manual Criterion Rd1000